I think it is also possible to put too much mineral spirits in. That is what I did and it appeared that the paint was separating from the minerals spirits once applied. It is also possible it wasn't mixed vigorously enough before appling. So just double check that you are mixing it enough and its not being mixed way to thin. From one extreme to the other for me.

My test peice is on hold for 2 weeks until I can get back to my parents to finish it. I'm having problems with the paint not laying down flat. I get alot of bubbles when I apply it, and good huff and they are gone, but where the bubbles were it is peally. I've tried running the roller over it again lightly, but it just makes the peal smaller in texture.

Any ideas on how to get it to lay flat? is everyone getting a little peal and then just sanding it out? Also, I'm using 400 grit to get the peal out, but then there is pretty well no paint left once it is out and am back to square one. What am I doing wrong?