Everything seemed to be going so smoothly on my test piece, two coats 600, two coats 800, two coats 1200(couldn't find 1500) and then a final once over with 2000. Ahh! finally to the buffing stage. It was then that I realized something was terribly wrong. When I went to buff it out I was burning through the top layer of paint and the difference from that and the next coat down is highly visible. I'm thinking my coats must be far to thin. I thinned my paint around 40% and was "wetting" the surface on each coat but the coats were so thin I burned right through them. Marq, Exit, Charger, Dart...Anyone got a good idea of how I can get a thick enough coat so that I don't wetsand through it?