Very nice work. That is a good amount off the front. This thread I believe, brings back the fundamentals of Tinkering with Hot Rods. It's what makes it fun again.
I figured it out this way as a general break down of the ideas vs labor vs cost. * There will be at the most, 15 places on a car or truck where 20 or more lbs can be removed or replaced. * There will be at the most, 20 places on a car or truck where 10 or 5 lbs can be removed or replaced. * There will be at the most, 25 places on a car or truck where 1 lb can be removed or replaced. * There will be at the most, a 100 places on a car or truck where eight ounces or less can be removed, but not necessarily replaced, But.........if replacing, the most expensive small parts or fasteners are where one pound down to an ounce will be addressed.
Check the Titanium K-member bolts. Saved only 1/2 Lb.
