Thanks for the info Dave! Now I understand the way that thing sounded on the dyno! I am planning on a set of the Enginequest heads too but I'll probably use the 60711 Hydraulic roller from Lunati for the bottom end torque etc. Thanks again! What diameter are the stubs for your primary tubes?
Quote: Yes, Dan at Performance was able to internally balance it. I don't think he had to use Mallory Metal, but I'll ask him. I used this Comp Cams cam. Nostalgia/Purple Plus Hydraulic camshaft The block was decked for optimum quench. I used magnum heads, which have closed chambers. Hope that helps.
What diameter are the stubs for your primary tubes?
