Quote: looks pretty sweet. did you use a floor jack handle, for a front driveshaft?
that thing is getting tall. will it fit inside the garage, with the rollcage and lights, and stuff?
I used PVC pipe to mimic the driveshafts.
Yes, this thing is tall, taller than I was expecting. Look at the pic, and you will see a piece of aluminum flat stock clamped to the tub. It is the same height as the windshield. I took some measurements, and right now, I would have to remove the bottom hurricane brace on the garage door in order to drive it out of the garage...maybe. It would be REAL close. I'm hoping that with the addition of the weight of the bumpers, rock sliders, rollcage, spare tire, front and rear seats, etc., that it will settle down another inch or two. If I need more clearance, there are several options available to lower it a little more.
Gone to the dark side with an LS3 powered '57 Chevy 210
