I've been trying to figure out the rear shock mounts since I got the car. The car came with Rancho shocks but they were about 6 inches too long to fit. I bought the shorter shocks from Calvert but they were still too long. Finally decided to build my own shock plates to make it work. While I was designing the plate I decided to change the lower shock mount to a double shear rather than the cantilever pin. The double shear is stronger and easier to put together. Just push the bolt thru the bracket rather than trying to twist the shock on over the upper and lower pins. Here are a couple of pictures of the first prototype. I think this design will work so now I just need to refine it and make some more.