Yes I know this topic has been run into the ground but I'm a dummy and I want to get this right the first time. I have 4 degree down on the tail I have 7 degree down on the pinion This is a cal trac setup in an a body anywhere from 3100 to 3300 pounds. Those reading put me at 3 degrees Is this ok for a strip car?
better re-calculate that. 4 up on the pinion would put you at 0*, then you would have to roll down to what ever you wanted it set from there. 7 down puts you at 11* down
I can't believe I agree! LOL
With Cal Trac and the tail being down 4, you want the pinion at 1up to 0. That will give you a -3 to -4 setting. If Calvert says -2 to -3 then you want the pinion up 1 to 2.
