Quote: Just thinking unshouding can open the CC's up a bit as well as flow to help lower compression.
A think gasket and a bigger bore size at that will help a lot!
I just got back from the machine shop and expect to get the heads back tomorrow. Pictures will follow. They look great. The man was finishing up with a fresh valve job and new stem seals. They measured at 83 ccs. I did the math on the compression calculator and I will end up at 9.77 with an .086 head gasket and 10.0 even with the .075 gasket. Over the weekend I cleaned the tops of the pistons and found that they were actually .012 in the hole instead of the .017 number that I wrote before. I think the machinist may have resurfaced the decks when I had the block in for honing in 2011.
