Correct except for Robb Robb mc, LINKY and Brewers pins which are sized correctly.

My error was twofold,
1. I did not think about the BH side of the dowel which also has to be reduced. That error pushed the offset portion into the block enough to seize it. but fortunately only on the lower accessible pin. The never seize may have helped
2. Again not thinking things through I installed the pins with the offset 180 degrees out of where they should have been. again.

I am happy to say the new pins are in and the BH is +/- .0035 which is within spec. Amazing how easy things can be when you think things through
Will try for the clutch etc tomorrow