Yes I know Fury fan I don't have the money laying around for that distributer either. Just thought I would point out that it is out there. I am a long ways from a running engine Working on a full restoration and in the assembly phase. I have collected most of the parts needed for the mass air system and still trying to figure out the dizzy. I have looked at the other hall effect dizzys but dont want to waste money on something that may or may not work. The small block guys other than the rotation issue seem to have it easy there is room for a modified ford dizzy. The diameter is too big for a 440 it hits the valve cover. My plan was to make an adaptor redo the end of the shaft and run it, till I got one in my hands there is no way to make it fit. I hope moving the ford guts works so I can copy it. I might try running points to start just to see if it works.