Starting to make progress on the body. Door gaps being reworked...


Filler work, sanding, primer, sanding...sanding...sanding...more sanding...






I bought a reproduction gas cap and it sat a good 1/8" to 3/16" below the surface of the 1/4 panel. I looked at a lot of A-bodies at the Mopar Nats and most of them showed the same thing. I'm not sure if they were normally like that or not but I didn't think it looked right. The body shop fixed the issue. Not sure exactly what they did but it looks much better now.




bumper fitment. I bought some AMD bumpers when Tamraz had their 50% off sale. The front bumper fit ok. The rear did not. The top of the bumper was touching the body just below the tail light opening. There is supposed to be a 3/8" rubber filler under the tail lights so the bumper was up way too high. The bumper brackets were modified to lower the bumper.