Alright so today wasnt anything to much special, but did make progress. Good things happened today...

First before any finishing work was done to the hood i wanted to get the hood pins drilled and mocked up. Got this kit for the car last christmas from my girlfriend



Put the rod in its location then put paint on the top of them and closed the hood to make sure they closed where they should...you can see the dot of black at the top...



Once the main hole was drilled (drilled it larger than factory but think weight savings ) put the gasket down and drilled the four screw holes. Then put the bezel on and threaded the screws...



Also worked on getting the front end aligned. Had to swap hinges today too. I stole them from my challenger so i need to find a set for them. The gaps look good and everything is lining up good as well...



Also sprayed the decklid in primer again and then did the final sand on the valances (paint for them is tommarrow