Well we started tearing into "project wheel well restoration. I am doing the lower part while greg does the upper part. Here is the piece greg is using...



He started cleaning it up and found some nice pin holes


Cut out the old tub, look at that rust




My half of the project...

I first welded on the rocker cap...


I then mocked up our fabulous replacement tub


I trimmed it down and started in on the fabrication of a new lower half...



Once the new flange was on i tacked another piece on for fitment and to see look at some angles for bending it...



Then i bent the piece and welded it on...


Then put on another piece...


Then i mocked it up again and its all but done except for the flange that the quarter welds to...


I also finished up the dutchman corner...


Also looking forward to replacing this little bit of floor (right rear Corner)