Devil There are quite of few cars in there, and complete at that. You lucky to find half those parts on the yards i go to.

Did a little work to get the trunk assembly ready to go in. First was to repair the drivers side trunk extension. Cut the new reproduction piece for patches. I know some of you may thank that is nuts but its much easier considering the fitment of those pieces is not very good. It would take a lot more to make then fit than to patch. Plus its good practice!


Here is the lower patch, as you can see the holes for the drain plugs are different sizes all together...


Butt welded in place!



The upper lip by the wheel housing needed attention too.



Butt welded in!




I started on the passenger side but its bedtime for me. The repro piece doesnt have the flange so ill have to salvage the one off the original extension...