Quote: this is for Monte_Smith- I've got a 68 Dart. Its a chassis car with ladder bar suspension. Dana 60 rear, 4.56 gears, all Moser internals. 32 x 14.5w slicks. The passenger rear is squatted down about 1 to 1.5" just sitting there. The car weighs 2835 with me in it. 9.28@143.35and a 1.31 60' If the spring on that passenger shock is't bad, is my housing bent?
No.......that's not the way they bend. Your car is sitting crooked because of your corner weights, bent chassis, tab in the wrong spot, or something similar...But probably just the corner weights are not right.
Is it ladder bar? If so remove the bottom bolt of the bar at the housing and recheck your weights. Remember to put your weight in the driver seat and adjust springs and torsion bars then set preload. Every so often pull the bolt to see if anything is not bending.With everything bolted up you can not jack springs or torsion bars.
Lf is 708 RF is 623 LR is 730 RR is 773 I'm hoping its just a spring issue
cudaman1969- Yes Its a ladder bar set up. It is a full Tube chassis car (8.50 chassis). Strut front end.
Greg
----------------------------------------------------------------- Cost is irrelevant, making memories is far more valuable!
