Quote:

Quote:

did you re-degree it after you advanced it to make sure it only went 2 more degrees? i wouldn't assume that it was right. why not just put it back at "0" where you new it was at 8 1/2 like stated earlier and run it like that?



Hello, Yes, I did check a couple time to make sure I only went 2degs. If I am correct with my degree method and it is only 2 deg advanced from actual zero, straight dot to dot, I can't see that could possibly be causing my problem. I wouldn't think 2 deg one way or the other can cause this much problems. I have thought about moving it back to zero. I've also thought about getting another timing set and checking it against this one. Take care, Jeff






Move it and check compression..



Chris..