Quote:

---

I think I may build this combination, I found some 18" steel wheels that may fit if I cut the centers out and move the back spacing to the center. If I use the discount rotors and get a rebuilt caliper, I can fit it up quite well before it ever goes on a car. Tim

---

That must be a really impressive steel wheel.

I haven't seen one yet that will clear a caliper that size on a rotor as shallow as those.

I strongly suggest you find a SRT Jeep and break out a measuring device. The center hat of the rotor is less than an inch away from the rotor surface. The caliper sticks out nearly three inches from the surface of the rotor.

Your wheels are going to smash the caliper before you can get the lug nuts on. There's a good chance it will contact the outer radius of the caliper too.

Mission: Impossible.