Thx guys...

Still trying to complete a few things...

The list I had of 50 some odd items is down to about 10...

Since I have had to fabricate everything for this I don't know why I thought the 65 A 990 seats and factory SS seat brackets would work...

They would be fine for Rico Abreu...

I'm short and I can't drive it where it ends up...

I've made templates to move it back and also up a little...just need to start fabricating them up...

I put the front yoke on the driveshaft and just set it up in the rear yoke...

One quick glance and I am going to have to modify a few things as the pinion needs more angle...

Moving on to a few things I thought would be easier I needed to find a way to mount the air cleaners or velocity stacks on the 660 carbs...

They sell a bracket but at $60.00 each that isn't going to happen...

Some flat stock and a 1/4-20 coupler along with some cutting...welding and grinding and all is good...

All of the front brake hardware and lines are completed...

Waiting on a new rear brake hose for the rear end and I can then bleed the brakes...

I did pick up the tags and put insurance on it so when it is ready I can take it around the block without any grief...