Quote:

Quote:



That's when I put the wording in my sig below......



And the wording in your sig line is why I had my crank hung in the grinder & checked.... My machinist said it was spot on & that he'd seen quite a few high $$ cranks that had worse taper & indexing issues.. So either I got lucky or Brandon took your comment & did something about it...



That's cool .........I'd actually bought quite a few cranks from him until that last deal broke the camel's back.........All the others either needed the rods or mains (or both) turned, but they were indexable and useable.........

If you can't handle the truth, you're living a lie.......