Liberty's Gears All Motor - AM
1/4 Mile - .400 Pro Tree - 16 Car Qualified Field - Pro Ladder

Rules are subject to change. We will also review them after the third race.

Base Weights
Small Block minimum weight 2800 pounds
Big Block minimum weight 3300 pounds
Big Block Chevy, Mopar, Ford, Cadillac Conventional Head minimum weight 3150 pounds
Big Block Buick, Oldsmobile & Pontiac minimum weight 3150 pounds
Lower Engine Containment Device Required:
Oil Retention Device: Device may be custom-built ballistic blanket-style or metal-style (I.e., bucket) device. Metal pan may be no longer than the engine from the front of crank shaft to the rear of the flywheel. Pan must be inside the frame rails and fabricated to retain oil\liquid. Pan must attach to the frame via conventional fasteners or straps. Pan must be a minimum of 3inches above ground.
Diapers: They do not have to be SFI rated.

Carburetors
Carburetors: Single carburetor allowed. Any modifications are allowed. No split carburetors allowed.
Fuel Injection: Electronic fuel injection is allowed. Single throttle body required.

Intake Manifolds: No restrictions

Mufflers: Mufflers are optional.

Transmissions
Auto Transmissions: Any OEM American automatic transmission or a replica of an OEM American automatic transmission that uses planetary gears and torque converter permitted. Transmission-to-engine adapters are permitted. Trans brakes permitted. Automatic transmission entries run at listed base weights. Pneumatic, electric, hydraulic, etc. shifters prohibited. Any gear change must occur from direct action by the driver.

Manual Transmissions: OEM or aftermarket transmissions with a maximum of 5 forward speeds permitted. Clutchless models permitted. Any gear change must occur from direct action by the driver. Pneumatic, electric, hydraulic, etc. shifters prohibited. Vehicles using Clutchless manual transmission must add 50 lbs to listed base weight.

Front End: Stock frame rail from firewall forward required. Firewall to remain in the original location. Bolt-on replacement units allowed. This needs to be verified in tech that the bolt on factory mounting point are used with the bolts present.

Front Suspension: Any type of suspension is allowed

Rear Suspension
Stock Suspension: Deduct 25 pounds from base weight
Ladder Bar: Runs at base weight
4-Link: Add 75 pounds to base weight

Wheelie Bars: Wheels must be non-metallic. May not be attached to rear bumper or bumper braces. May be 48 inches in length or to the rear bumper, whichever is longer. Length is checked from centerline of rear axle to center of wheelie-bar wheel.
Add 50 pounds from base weight if using wheelie bars

Rear Tires
Slick Tires: Mickey Thompson 28.5 x 10.5 Non W or 29.5 x 10.5 Non W Only
Body
Exterior:
Body panels can be replaced with factory appearing bolt-on replacements. No one piece front ends - Aftermarket front end that is all connected together (both fenders and nose).
OEM style forward facing hood scoop are allowed, Pro Stock style forward facing hood scoops are allowed, add 100 pounds to the base weight.

Glass: Lexan is allowed in the doors, side widows and the back

Interior: Stock appearing interior required, including two front seats.