Quote: I assume you are using teh degree plate to measure the degree of turn on the wheels as you measure caster. Wha degree are you turning to? 20 degree? 30 degree? I would be interested in knowing this. Thanks.
"IF YOU'RE UNDER CONTROL, YOU AIN'T GOING FAST ENOUGH."
If you are doing it on some sort of modern alignment rack the machine will tell you the angle or set point.
A Longacre caster camber gauge can use a degree plate, but there is also an angle machined on the edge of the gauge. You turn the wheel until the angle is paralell to the car. OR mark the rotations on the steering wheel (tape mark on wheel) and make sure the wheel is turned the same exact amount both ways from center.
