This 1384 ignitor kit didn't come with anything to set the gap between the module and the magnet and it looks like it's not supposed to. So, is there a way to make sure it's in the right place?

The module has a hole in the center of 2 other holes that allows for a screw in the same place as the one for the condenser. It has two other holes, one on each side of the one for the screw, that fit over a couple of small posts that were locators for the condenser I assume. I haven't tried to start it yet, but it looks to me like a fairly large gap between the module and the magnet so I want to be sure if it doesn't crank whether it's the position of the module or the timing being way off.


1970 EK2 T/A 727