Quote: Thanks very much for the info. I understand what everyone is saying. I will get the rims/slicks and figure out the width the rear housing has to be.
I now have the body mounted on a rigid jig perfectly leveled, since i removed the rear half of the car. Before I proceed with actually fitting and welding the rear frame rails and crossmembers in, does the body have to be removed off the jig for mock up? I am thinking I can lift the rear up to where I want it to sit at ride height and do the mock up with it mounted on the jig. I do not want to remove it because I don't want anything to move before the frame rails and cage go in.
Thanks again, Greg.
I'm doing a full chassis right now... next week I'll roll my chassis jig in and set the car on it... I use the jig as the ground surface then reference from that This is where I'm at now
