Thanks, I did call him back. He had shipped my order already...

but I'm good - NAPA had the correct gasket and I put the pumpkin in yesterday... Also got the rear end back in the car before it started raining, hung the leaf springs back up.

Next I'll push the brake plate studs back in the flange so I can slide the brake plates on and reinstall the brake cylinders, brake lines, and bleed it.

IIRC Cass said the steel crush gasket goes against the axle flange, with the rib against the flange, then the foam gasket, then the brake plate.. ?...

..I'm a bit unsure about that sequence, but I'll check my FSM or call Cass again before tightening it all down.. *

Cheers,
- Art

* I won't be tightening much of anything down until its time to tighten the retaining plate bolts - after I get the new bearings on the axle shafts and slide them in..

Last edited by 67SATisfaction; 10/14/16 11:22 AM.
65 Satellite hardtop 361/4bbl console 727 2.76
67 Satellite convert 383/2bbl column 727 3.23
67 Lancia Fulvia Sport 1.3 Zagato. Alloy body, 1.3L V4 DOHC 4-spd
67 Lancia Fulvia Rallye 1.3. Alloy panel, 1.3L V4 DOHC 4-spd
71 Alfa Romeo GT Junior 1300 Zagato, 1.3L 4cyl DOHC hemi 5-spd
82 Alfa Romeo GTV6 2.5L SOHC hemi V6 5-spd transaxle
75 Maserati Bora US spec 4.9L DOHC hemi V8 5-spd ZF
77 Maserati Khamsin Euro spec 4.9L DOHC hemi V8 5-spd ZF
07 Aston Martin DB9 6.0L DOHC V12 6spd transaxle