Got the passenger header in, lots of room (TTI room, which means 1/8" inch). The driver side on the other hand I had to cut the subframe lip off a bit and move the brake splitter back about 2 inches and rearrange the brake lines out of the way for clearance. The worst of it though is the headers just hit the t-bar. I am using the taxicab bars (0.96) and if I had girlyman weenie bars I'd probably be ok. Calling TTI tomorrow as I sure don't want to hammer on these headers if I don't have to. Also the instrucs say to pull the driver side t-bar, you have to pull both t-bars (no biggie)
I got the trans-dapt remote oil filter (the 1.5-20 metric one) and the lines themselves are still normal thread. Tomorrow I'll be calling Milodon (that's who did the remote filter setup for TTI) and drop serious coin (dammit).
