ok, my turn. i set the dial indicator and then turned the crank 90 deg each time. set the indicator at 0 at 6:00, and these were my readings the first time around:

0
.014
.001
-.012

discouraged, i decided to test the squareness, and so tore the indicator down and with it set at 0 at the bottom, had .005 at the top. not bad. i still may have the machine shop square it up.

did the setup again for out of round and got:

0
.012
.002
-.013

so, i have some .007 offset dowels. do i wait and get some .014's or do i just go for the .007? that will put me within range. FSM says .008, and the Robmc dowels I have say .010.

what would you do?