The cam is a Bullet solid roller. 269/275@50 on a 108 with .430 lobe lift. I called Bullet last week to speak with Greg about it, but he was out sick and the guy I spoke with could not answer all my questions. Greg is very hard to get ahold of when he’s there. Too busy.
If I have time today, I might be able to determine which lobes fit these specs. Assuming there is only one profile peculiar to 269/430 and again one to 275/430. These issues are more an engine builder issue than they are cam manufacturer. So you are the builder and bought the cam directly from them?
