This was the only area that didn't align well. The rest looked good . Door gap , dutchman panel , etc. was good. This part was too tall from where the glass will bed and too wide . Also the lower area was not curved correctly in the radius for the moulding to fit, and that made the verticle moulding too long as well. I have it close now and will fine tune it from here. .
Mark
My quarters are just like that. I admit thought I was pretty slick because I got the area where the glass lays on the side to fit nicely without cutting it (I held a piece of 3/16 steel in that glass channel and hit that with the hammer for quite a while to reshape that area, it worked better than expected), but when I test fit my molding recently
I found out I'm going to have to cut the bottom part exactly like you did to get the shape correct.
Your pics have definitely helped me out a bunch and I saved those + plenty of others in my FB album that you have probably noticed.
Thanks again Mark and keep 'em coming.
