Quote:

Quote:


I gots me a .466+ lobe lift flat tappet from Barton that will go in first...Then a Old crane grind which has about .475 lobe lift roller. I say this cause i dont know what ration these rocker arms are, some say 1.6 some say less.

Compression is 14:1


Do i win a prize Dan-O for the largest flat tappet on the web site or something...

I guess it would be funny if I was running a .500 lift cam talking about all this flow.





well, if i was going to give you a prize for that flat tappet that'll end up around .755 lift, it wouldn't be anything to be proud of.

by the way, the S/R heads won't even come close to the power potential of the raised port big valve or millenium stage 5's.

the reason i asked about the cams and combo's is because the supposed 10 cfm difference doesn't amount to squat. until you build something of real potential, it's meaningless and not even worth worrying about.

for example, go ahead and run that silly flat tappet cam and somebody else running a well designed roller 10 degree's smaller with 10 less cfm will put you on the trailer. see my point?




Like mine

5646825-CamCard.jpg (77 downloads)