I had damage on 3 rockers where the ball adjuster and pushrod cup were going away. The rest were ok but it would have just been a matter of time. 2 on the drivers side and 1 on the passenger side. 2 intake rockers and 1 exhaust.

I'm ordering new ball adjusters today from summit and will have to hustle for push rods tomorrow. I need to get through the show this weekend and regroup. I have plenty of oil up to the heads but as to why the it's not oiling the rockers properly is a mystery.

I have the shafts cleaned up and the rockers are turning nicely on them now. Once I get everything put back together I'm going to prime the motor and watch all the oiling holes. I'm also going to run some thin wire in the oiling passages on the rockers to make sure they're clear. Not sure what else to do at this point?