Quote:

I figure the only way to do it right would be to mill the stands and fit a paired Jesel setup




Nah, you don't have to mill the stands in most cases,or go with Jesels to do it right.

Quote:

The HS rockers do seem a little long and also causes a fitment issue on the pushrod side of the rocker for some valve covers with the Victors.




Extra length on the roller side means extra length on the adjuster side for a given ratio, and it causes clearance issues.

Quote:

Also, found this pic where I ran a sweep pattern without the lash caps.




The sweep is too wide, but by raising the rocker even more with the lash cap, it gets worse.


Mike Beachel

I didn't write the rules of math nor create the laws of physics, I am just bound by them.