Quote:

.674 sollid roller,



I'm right in the same ballpark lift-wise.
Quote:

PAC-1243)installed at 1.900



Same springs & installed height.
Quote:

Comp tool steel retainers...



I'm using ti retainers, which I'm good with as long as the springs don't have dampers that wear into them.
Quote:

Smith Bros .375x.083 pushrods



I'll be getting some new SB pushrods, but plan to use .120" walls for this much spring pressure
Quote:

Harland Sharp S70016EVK rockers.



Hughes' stuff on RAS shafts; no lash caps
Quote:

Also, don't forget about the possible center rocker stand breakage issue. I preemptively removed the factory helicoil and drilled/tapped and installed a 1.0 inch helicoil further into the head so the top of insert is just below bottom of stand.



Did that to mine after seeing the posts on the broken center stands.