Quote:

Then you need to make better baffles.. also where are
they located... during testing on the dyno I seen that
if your over the front wide rocker stand you get the
least amount of oil there
EDIT
also is it coming out between the rubber and the VC
or between the rubber and the breather





The oil is coming out between the rubber and the breather. I am going to pull the valve covers off today to check where the baffle is over, but I seem to remember it being over a shaft pedestal in the heads. The valve covers are the cheap fabbed type you can get from a variety of sellers on ebay.

I was thinking of drilling a hole into the valve covers to run lines to a puke tank, but not sure if that would need to be baffled either or if its a good place for it.

When using open breathers or a puke tank that breathes, is it helping to vent crankcase pressure?