I think the Strange is the same in respects to this as OEM. But you're saying my rear might not need the five hole plate? Because it isn't a stock 60?
I will put it back together and check it out. If I do have to put the spacer on, where do I put it? Do I put it right on the housing end flange or the outside of the kits bearing retainer plate and run the retainer nuts up against it there?

Sorry but the prospect of smoking the bearings right off the bat has me concerned about this kit. I know it's gotta be annoying.

Here is the "Exploded Assembly Diagram and Parts List" so hopefully that can show folks where 5 hole plate goes exactly. I would like to give Wilwood some feedback on this. It is hard to imagine people have been tearin up bearings with their kit and Wilwood hasn't corrected the instructions.