Quote:

I say find a local gearhead exhaust shop and have them bend up a 2.5 system. No reason to donate $$$$$ to TTI when you can get a full custom system made local. You are in MI, shouldn't be hard to find a guy.




I'd go TTI route over local...nobody that I know of in west michigan that I know of can mandrel bend, nearest I could find was either by detroit or chicago...compression bent 3" necks down to the same cross section as mandrel bent 2 1/4" in a 90 degree bend.

and I've been dissappointed with local exhaust shops in the past, and they aren't cheap either...my last full exhaust, with me supplying the flowmaster Y, header flanges, and dynomax 17769 muffler (big single) was over $275, with ugly compression bends and sloppy welding (after I specifically told them NOT to weld the aluminized pipe), where the welds rusted out in 3 years...

Last edited by patrick; 10/24/11 11:33 AM.

1976 Spinnaker White Plymouth Duster, /6 A833OD
1986 Silver/Twilight Blue Chrysler 5th Ave HotRod **SOLD!***
2011 Toxic Orange Dodge Charger R/T
2017 Grand Cherokee Overland
2014 Jeep Cherokee Latitude (holy crap, my daughter is driving)