|
Re: one-man brake bleeder kit
[Re: imfixinmopars426]
#946992
03/09/11 01:47 PM
03/09/11 01:47 PM
|
Joined: Jan 2003
Posts: 104,346 Garden Grove, CA
OzHemi
Penguin-hating Ginger
|
Penguin-hating Ginger
Joined: Jan 2003
Posts: 104,346
Garden Grove, CA
|
Quote:
i made my own pressure bleeder,plate of aluminum,a rubber gasket w/ slot in center so psi will get to both sides of resevior,and a hose in the middle of the plate. put air psi in the hose through a regulator at 5-10 psi. start at zero,and crank it up slow. i use c clamps,or whatever to fasten the plate to the master cyl. bleed a few times and ck level...works great,im always by myself.
I did the same exact thing years ago...used a metal plate with a piece of flat rubber glued to it to help seal to the master cylinder.
I do have a vacuum one too (mighty vac) setup that is good in alot of situations as well.
|
|
|
|
|
|