Quote: You only use 1 ballast. I'll assume the one on the dr side is the OE points ballast which the last high mileage one I checked was 1.6 ohms. The one with the orange box MP kit is a nominal 1.25 ohms. Either will work fine with your app but only use one & I'd wire it as I posted.
Ok, thanks Robert! So, if I wire it the way you stated, can I just eliminate the original ballast on the DS and run the blue VR wire to the upstream 12V run side of the ballast on the pass side by the ECU? That means I'd have three wires going into the upstream terminal of the ballast- 1 for the ECU, one switched 12V, and one from the VR. The other side of the ballast would have the brown 'start wire' and the (+) coil wire. Does this sounds right?
Thanks again guys for all the help. I just fired this thing up temporarily and it fired right up. Just gotta clean up the wiring and eliminate one of the ballasts and I should be good to go.
