ALL DONE........... everything is installed

I have the new MC installed,,,pushrod is back in with rubber grommet on the pushrod.

I put new brake lines on to plumb in the porportioning valve....

Just have to bleed the brakes.....

which opened up a new project ,,,,as i cracked open the rear bleeder screw,,,it broke off....
so.....i will put in another wheel cylinder or see if i can get the bleeder screw piece out ( doubt it )

also,,,,while i had the rear brakes apart,,,i noticed the pads were shot. ...so i guess it was a good thing the bleeder screw acted up,,,otherwise i wouldnt have pulled the rear drums off to look till the spring....