I made a tool that I could use to push out the center post from the bushing with a gear puller. This was a length of pipe that slid down on the center post and was held on with the nut. On the pipe I welded two nuts 180 apart this was for the gear puller to grab on to. Turned the lead screw on the puller to force out the center post, once apart. Then use a BFH and chisel to remove the outer metal shell. A cutoff wheel on the center post removes the inner sleeve. Then put the new bushing in the freezer over night and use a press to in stall the new bushing and center post. I will try to post a picture later.