Quote:

Whats it look like in the car? The front 2 tubes must go under the K member? Hows the starter clearance, Do ya have to remove any tubes to get it out?

Kasey



Kasey, I will try to eventually get you a pic of the headers in the car. Maybe after they are coated. I did not look specifically with starter removal in mind at that header. I did decide to keep the tubes farther away from the starter than last time so I think it might be possible to remove the starter. Maybe you might have to remove just one top tube section or possibly drop the lower section and leave the top tubes. To tell you the truth, it was never a concern of mine because I can remove the header in about 20 minutes and that includes jacking the car up in the air a couple feet and placing it on Jack stands.

Yes, BOTH sides, 2 tubes go through the K-Member. Those headers are pretty much a copy of the Crate motor headers. Here is a pic of the crate motor headers. Sorry it is not that good..

6135936-MVC-007S.JPG (256 downloads)
SRT DEMON ONE SEAT