Quote:

---

Quote:

---

i guess no W series heads will bolt on now...?

that is alot of milling...

those bell house openings wont effect sfi...
as far as trans,flexplate,converter?
I realise it will let heat out..but if there is a trans failure..it migh fubar the block...?
(mount hole pads..)

did you do the lifer bores /* ..or where they already done...?


cheaspt.

---

There are pics of the 10 bolt INDY heads on page 5....

This was a tall deck "673" 48 degree block, so the lifter bores were already machined if that is what you are asking, although I do have capability to put lifter bores in a blank bore block, in fact I just did one for a dirt track racer last month.

I've done the window milling on the bellhousing to alot of blocks, in fact some of the 9" deck Nascar R3 blocks came W/ window mills from MP & were ran in Nascar competition like that. Have never heard anyone question their safety.

---

Cooll thanks for the reply..
Ryan ..those lifter bores are in pretty good position when shipped,?
you dont have to address anything there?
i was just wondering on the windows..not bashing..just ...i am used to carnage from time to time. lol.....wonder it that might factor..?

so i guess your putting in a pool at the house after all this ?


just having fun..
keep up the good work...
cheapst.