Quote:

Quote:

Quote:

Now for the question if the housing has a small opening,

IT DOES, will it cause a cooling problem, seems to have for one. Not sure for anyone else

The narrow passage is only the feed ( back to the block ) lower passage on the passage side. All other passage look fine and closely match a factory housing.



Bashing aside... is there enough "meat" in the narrowed area to open it up to factory dimensions, with a die grinder and burr?

-Charles



I was wondering about that as well.



I would "ASSUME" there is,but if that be the case,once again,why was it not done from the beginning? Now I remember,short cuts save money!