I think my Donner was a '92 with no air bag / variable voltage but I will confirm the year if it is not. I used the OEM column but it is never easy into a different body.
This is the only picture I have of the column at this time.
As far as the frame splice, after much research and consultation with Gene, and me over complicating things, the key items where:
compressing the front springs by redi-rod (all thread) to ride height, taking the front of frame / A arms angle measurements, and most critical squaring the frame to the original wheelbase.
All the other items will have to be adjusted to fit, engine setback, etc. My car was a registered vehicle and did not require an inspection.
Your frame probably is a different width so some of this is not applicable. I have a rambling disjointed build thread here:

https://board.moparts.org/ubbthread...ut-for-dakota-sub-frame.html#Post2443761