Originally Posted By Mr onetwo
Pulled the pistons last night and cleaned the bores.The ridge isn't as bad as it looks in the pictures.The crank journals look perfect and the rods seem ok although 1 is a bit tight.Will get the taper and wear measured by a machinist today.Do you guys have any other recommendations on what stock pistons would be best for better compression?I am going to try and find the best used set of pistons I can to save money.Thanks!


You have to have the ridge removed if you want to put in a taller CH piston in there, otherwise it might break piston rings.


running up my post count some more .