Mike,
Before you swap the wires, lets see if we can't figure out exactly what's causing the "binding".

Take a look at this pic. Do you have a pressure gauge that you can screw into these ports? Front Servo, Rear servo, and OD port are what we're interested in. Get it on the hoist and run it through each gear.

If you did, we can see if it's getting OD pressure in 1-2-3-OD, if it's getting reverse or intermediate (2nd gear) pressure when you put it in OD.

Basically it will tell us what is coming "ON" that shouldn't be causing this bind up...

Should look something like this Yes/No if it has pressure in each gear for each port.

Front Servo
1-No
2-Yes
3-No
OD-No

Rear Servo
1- Maybe (depends if low band apply) Either OK
2-No
3-No
OD-No

OD
1- No
2-No
3-No
4-Yes

2009-11-12_225648_ports