Quote:

Quote:

mark, here is a pic of where that chassis tube goes. i've been looking at bumpstops, but for some reason the ones i've seen that i think i want don't show the size specs [hint,hint prothane......]. it appears they are approximately 1 1/2" dia. x approximately 1/2- 3/4 thick[?] with a couple of center bolt bushings that appear to be for 3/8" bolts.

Hey Eric,
I can look through some catalogs for you if that is the size you are looking for?


Mark



thanks mark! they need to be no bigger than 1 5/8" od x 1" tall with a single mounting stud or bolt. if they were 1/2 to 3/4 tall, that would be even better. but i can trim them down in height if necessary.