|
Re: Milodon 31580 Road Race Pan Help
[Re: jbc426]
#1363596
03/03/15 01:18 AM
03/03/15 01:18 AM
|
Joined: Jan 2003
Posts: 5,394 Pikes Peak Country
TC@HP2
master
|
master
Joined: Jan 2003
Posts: 5,394
Pikes Peak Country
|
Quote:
Not sure if this info is helpful, but the pan fits in my 1970 e-body with 2 inch TTi's. The scattershield is more of a concern with the pan in my case. The pan has to be installed and the engine put in sans bellhousing and clutch to clear the k-member.
I ran into this exact same problem with my 74 Challenger, small block, 1 3/4 Hookers, and the Milodon road race pan. The pan sump is so freaking big, I couldn't get enough angle with the trans and bell housing in place to get it all wiggled down in between the motor mount blocks.
Once I drop the trans and bell housing, it dropped right in. Its a plenty snug fit, but it doesn't touch anywhere and nothing hits it, although I do have a single header tube within 1/2" on the passenger side.
|
|
|
|
|
|