As mentioned the heads are too small for that CID. Id go a little better on heads, but if you cant, CNC them for sure.

As far as a cam, to get to the 11s you dang sure dont need a roller. If that is all you are after, then ya, Id stick with a flat tappet.

Also, IMO dont call anybody listed in this thread for cam suggestions, but Dwayne Porter...nuff said.

Compression, IMO 383Man has it right, shoot for 11.0 to 1....if you are going to run some duration...if your gonna stay with the baby duration then cut back the comp....


Last edited by Von; 10/12/10 09:54 AM.

72 RR, Pump gas 440, 452s, 3800 lbs, Corked, ET Radials,. 11.33@117.72. Same car, bone stock 346s, 9.5 comp, baby solid. 12.24@110.