The US Cartool ones are total crap!

Barely ANY of the ridges/troughs of the edges that go into the floor pan valleys fit.

After trimming and trimming, I would stil lhave to "build-up" some of the HUGE (>1/4"!) gaps on one side towards the front, otherwise I'd have to reshape and cut down the whole thing 1/4".

I'm tempted to just slice through the floor pan and have the edges of the connectors drop through and weld. Then slice through the excess.

I SHOULDN'T have to do this crap! Why can't stuff just work after spending $200!?!?!

So...I'm wondering whether the XV ones are any better than the US CAR Tool ones.

I could spend another 10 hours or so (thank GOD the car's on a rotisserie!) but why should I? W/such huge gaps, the welds will not be pretty.

???