Quote:

Quote:



I'll look up the Petronix Ignitor II set-up for your Prestolite application tonight Troy, as there are about 6 applications for Mopar ignition set-ups



This is Mike? Pertronix 1382 Mopar 383413426 59-71 (may be the Ignitor series, not the Ignitor II's)






Troy that's the Ignitor I,...the Ignitor II is PN# PNX-91381A, you can only use this kit on the Chrysler distibutor,.....if you insist apon using the Prestolite unit then your stuck with the pn# PNX 1382 for the Ignitor I,.....I'd strongly recommend you purchase a rebuilt Chrysler RB SINGLE POINT dist for about $50, and run the PNX 91381A kit,....much more improvement over the earlier IGN I....the correct coils are Flame Thrower I PNX 40611, or for the Flame Thrower II, should you use the IGN II set up, PNX 45111,...I'd recommend you lose the ballast resistor in the system, you can still keep it for "looks" just gut it out, and solder in a #10 wire.


Mike